Paper
7 April 1999 Quality of optical components and systems for laser applications
Author Affiliations +
Abstract
The requirements for optical components and systems which are used for laser applications are different and normally stronger compared to standard applications. First of all, the quality is determined by the optical design of components and systems are used for different applications from DUV to NIR. Furthermore, especially in high power systems the properties of the optical elements limit their general use and their life time. For the industrial fabrication of optics in large quantities special production procedure and additional measurements for the characterization of the quality have to be performed. As is well known, the short term as well as the long term stability is limited by the material, the polishing quality and the coating. Therefore toady new standards for specification and testing of absorption, scattering and laser damage are applied in the industrial fabrication. Standardized laser components and typical data of surface quality and damage threshold will be discussed.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Rainer G. Schuhmann "Quality of optical components and systems for laser applications", Proc. SPIE 3578, Laser-Induced Damage in Optical Materials: 1998, (7 April 1999); https://doi.org/10.1117/12.344430
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Optical components

Laser applications

Lenses

Coating

Standards development

Laser scattering

Laser systems engineering

RELATED CONTENT

Standardization in optics characterization
Proceedings of SPIE (November 16 2018)
Standardization in optics characterization
Proceedings of SPIE (November 02 2000)
ASTM And OSA Efforts To Develop An Optical Surface Roughness...
Proceedings of SPIE (September 03 1985)
Surface-Roughness Monitoring For Industrial Quality Control
Proceedings of SPIE (January 01 1987)

Back to Top