Paper
18 May 2005 Variability in the performance of MIL-STD-810 sand testing
Author Affiliations +
Abstract
Exotic Electro-Optics (EEO) recently completed a series of MIL-STD-810F, Method 510.4 sand erosion tests at multiple commercial testing sites. During this testing process, it became apparent that no two environmental test vendors are alike, even if MIL-STD-810F is specified in all cases. Three different test laboratories performing the same Method 510.4 sand test on identically fabricated samples yielded three different results. Ultimately, it is the responsibility of the Engineer to confirm that the test vendor’s equipment, processes, and procedures produce a test environment that is applicable and a result that is accurate based upon the customer specified test requirement and the MIL-STD-810 methodology. Some critical factors that determine the utility of a test are particle concentration, air velocity, particle size and composition, and the ability to maintain these parameters over test duration of up to 90 minutes. EEO has identified a number of parametric details critical to maximizing the stability and accuracy of MIL-STD-810F, Method 510.4, Procedure II sand testing. These strategies will be presented.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Keith T. Jacoby "Variability in the performance of MIL-STD-810 sand testing", Proc. SPIE 5786, Window and Dome Technologies and Materials IX, (18 May 2005); https://doi.org/10.1117/12.604136
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Particles

Transmittance

Coating

Calibration

Optical inspection

Humidity

Fourier transforms

RELATED CONTENT


Back to Top