Critical dimension variations of I-line processes due to swing effects

C. Berger; R. Schiwon; S. Trepte; M. Friedrich; M. Kubis; J. Horst; A. G. Grandpierre

doi:10.1117/12.655131

24 March 2006 Critical dimension variations of I-line processes due to swing effects

C. Berger, R. Schiwon, S. Trepte, M. Friedrich, M. Kubis, J. Horst, A. G. Grandpierre

Proceedings Volume 6152, Metrology, Inspection, and Process Control for Microlithography XX; 61523T (2006) https://doi.org/10.1117/12.655131
Event: SPIE 31st International Symposium on Advanced Lithography, 2006, San Jose, California, United States

Abstract

As chip dimensions decrease, I-line processes remain of interest for most uncritical layers: they provide the needed performance at a low cost and high throughput. However the critical dimensions (CD) and overlay requirements for the newest technologies are much tighter than they used to be, reducing significantly the process windows. Sources of variations of CD range and CD mean should be well known and the process window set up so as to minimize the sensitivity to small variations. For lower resist thickness, although using partially dyed I-line resist, one may have to deal with huge swing effects. Resist thickness and stack variations are then the main contributors to the high CD distribution This article focuses on CD instabilities caused by resist thickness fluctuations in the case where a stack layer is subject to variations. The influence of resist thickness variations is first considered, pointing out the importance of thickness control methods. The real resist thickness repartition on stacked wafers depends not only on global coating uniformity but also on local topography. Some examples of resist repartition and its impact on CD-uniformity are provided. The added contributions of resist and stack to a global swing effect are then discussed on the basis of experimental data. Significant differences of swing behavior are experimentally observed between critical chip structures and the usually monitored PCI kerf structure. A simulation illustrates the effect of the local stack thickness and resist thickness and to better understand those differences, together with cross section thickness measurements. The choice of an appropriate CD control structure is finally dealt with.

Citation Download Citation

C. Berger, R. Schiwon, S. Trepte, M. Friedrich, M. Kubis, J. Horst, and A. G. Grandpierre "Critical dimension variations of I-line processes due to swing effects", Proc. SPIE 6152, Metrology, Inspection, and Process Control for Microlithography XX, 61523T (24 March 2006); https://doi.org/10.1117/12.655131

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available