Edge placement error reduction and ringing effect suppression using model based targeting techniques

Chris Cork; Xiaohai Li; Stephen Jang

doi:10.1117/12.916623

13 March 2012 Edge placement error reduction and ringing effect suppression using model based targeting techniques

Chris Cork, Xiaohai Li, Stephen Jang

Author Affiliations +

Proceedings Volume 8326, Optical Microlithography XXV; 83261U (2012) https://doi.org/10.1117/12.916623
Event: SPIE Advanced Lithography, 2012, San Jose, California, United States

Abstract

With the delay in commercialization of EUV and the abandonment of high index immersion, Fabs are trying to put half nodes into production by pushing the k1 factor of the existing scanner tool base as low as possible. A main technique for lowering lithographic k1 factor is by moving to very strong offaxis illumination (i.e., illumination with high outer sigma and a narrow range of illumination angles), such as Quadrapole (e.g., C-Quad), custom or even dipole illumination schemes. OPC has generally succeeded to date with rule-based techniques for dissecting edges into segments and placing target points. Very strong off-axis illumination, however, creates pronounced ringing effects on 2D layout and this makes these simpler dissection techniques problematic. In particular, it is hard to prevent overshoot of the contour around corners while simultaneously dampening out the ringing further down the feature length. In principle, a sufficiently complex set of rules could be defined to solve this issue, but in practice this starts to become un-manageable as the time needed to generate a usable recipe becomes too long. Previous implementations of inverse lithography demonstrated that good CD control is possible, but at the expense of the mask costs and other mask synthesis complications/limitations. This paper first analyzes the phenomenon of ringing and the limitations seen with existing simpler target placement techniques. Then, different methods of compensation are discussed. Finally, some encouraging results are shown with some model based techniques that the authors have investigated, some of which only demand incremental changes to the existing OPC framework. The results show that new OPC techniques can be used to enable successful use of very strong off-axis illumination conditions in many cases, to further reduce lithographic k1 limits.

Citation Download Citation

Chris Cork, Xiaohai Li, and Stephen Jang "Edge placement error reduction and ringing effect suppression using model based targeting techniques", Proc. SPIE 8326, Optical Microlithography XXV, 83261U (13 March 2012); https://doi.org/10.1117/12.916623

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE