Presentation + Paper
26 August 2024 Unlocking the potential of non-ferromagnetic Invar-type alloys in space exploration
Author Affiliations +
Abstract
The effects of Fe and Mn on the thermal expansion characteristics of non-ferromagnetic Cr-Fe-Mn alloys, which exhibit the Invar effect, were investigated. It was found that the temperature range in which the alloy exhibits low thermal expansion characteristics is below 273 K when the Mn content is less than 0.3%. Conversely, this range shifts to between 273 and 350 K when the Mn content increases to 0.9% or higher. By incorporating small amounts of rare earth elements, the Cr94.6Fe4.7Mn0.7 alloy achieved an average coefficient of thermal expansion of 0.94 × 10−6/K between 273 and 350 K, which is lower than the 1.2 × 10−6/K observed in conventional Invar alloys. Additionally, measurements of magnetic hysteresis loops were conducted to assess the residual magnetization, which is critical for structural components near magnetic measurement equipment. The results indicated that the residual magnetization of the Cr-based Invar-type alloy is approximately 0.0033 mT, significantly lower than the 35 mT typically found in conventional Invar. These substantial differences underscore the potential of Cr-based Invar-type alloys as a superior alternative for applications requiring low thermal expansion and low residual magnetization.
Conference Presentation
(2024) Published by SPIE. Downloading of the abstract is permitted for personal use only.
Hiromichi T. Fujii, Shingo Matsumura, Naoki Sakaguchi, Haruyasu Ohno, and Kotaro Ona "Unlocking the potential of non-ferromagnetic Invar-type alloys in space exploration", Proc. SPIE 13100, Advances in Optical and Mechanical Technologies for Telescopes and Instrumentation VI, 131000L (26 August 2024); https://doi.org/10.1117/12.3017918
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Alloys

Magnetism

Manganese

Chromium

Iron

Materials properties

Temperature metrology

Back to Top