Paper
16 August 2004 An in situ test structure for simultaneously determining multimaterial properties of a film
Author Affiliations +
Abstract
We present a set of in-situ test structures for simultaneously determining residual stress (RS), Young's modulus (YM) and thermal expansion coefficient (TEC) of a film. Analytical models as functions of the displacement, geometry and material property of the test structures are theoretically derived for the task of extracting the film properties. This method utilizes available measurement apparatus and all the properties are identified and quantified on the same apparatus. The test structures consist of the measured film and the calibration film and are fabricated by a simple sacrificial-layer micromachining technique. The measured films made of undoped LPCVD polycrystalline silicon and the calibration film made of PECVD silicon nitride are used to demonstrate the effectiveness of the proposed method. The average calibrated residual stresses of undoped polysilicon films with deposition temperatures of 600°C and 620°C are 105± 5MPa and 240 ± 10MPa, respectively, and the corresponding Young's moduli are 170± 5GPa and 150 ± 5GPa. But the thermal expansion coefficient is approximately 2.7x 10-6 average.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Chi Hsiang Pan "An in situ test structure for simultaneously determining multimaterial properties of a film", Proc. SPIE 5455, MEMS, MOEMS, and Micromachining, (16 August 2004); https://doi.org/10.1117/12.545231
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Calibration

Silicon

Silicon films

Microelectromechanical systems

Low pressure chemical vapor deposition

Micromachining

Remote sensing

Back to Top