Paper
1 December 2008 Advanced technology for after-develop inspection
Z. Y. Chen, I. C. Chou, J. H. Yang, Wallas Chen, Josh Chang, Henry Chen, Melvin Ng, Meng-Che Wu, Cathy Perry-Sullivan, Mingwei Li
Author Affiliations +
Proceedings Volume 7140, Lithography Asia 2008; 71400Y (2008) https://doi.org/10.1117/12.804661
Event: SPIE Lithography Asia - Taiwan, 2008, Taipei, Taiwan
Abstract
This paper describes a methodology for after-develop inspection (ADI) using a broadband DUV/UV/visible brightfield inspector with a unique optical mode. The VIB (Varied Illumination Brightfield) optical mode enables capture of unique killer defects at low nuisance rate on certain 45nm and 32nm ADI layers, significantly improving litho inspection sensitivity. By implementing this inspection, defect engineers were able to detect critical excursions at ADI rather than at later process steps. This shortened process development time and allowed for re-work, significantly reducing wafer cost.
© (2008) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Z. Y. Chen, I. C. Chou, J. H. Yang, Wallas Chen, Josh Chang, Henry Chen, Melvin Ng, Meng-Che Wu, Cathy Perry-Sullivan, and Mingwei Li "Advanced technology for after-develop inspection", Proc. SPIE 7140, Lithography Asia 2008, 71400Y (1 December 2008); https://doi.org/10.1117/12.804661
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Inspection

Wafer-level optics

Signal to noise ratio

Deep ultraviolet

Semiconducting wafers

Metals

Defect inspection

Back to Top