Paper
26 May 2010 Characterization of line-width roughness about 22-32nm node EUV mask
Author Affiliations +
Abstract
Achieving the specifications of line width roughness (LWR), sensitivity and resolution of wafer resist is one of the top challenges of bringing extreme ultraviolet lithography (EUVL) into high volume manufacturing. At the same time, EUV mask LWR is set on very ambitious target value from ITRS [1] because mask LWR would contribute to wafer resist LWR more strongly than that of ArF lithography due to dramatic decrease of wavelength. Mutual relation between mask and wafer resist LWR has been discussed [2] [3] but not frequently, so standardization of mask LWR measurement is not fixed. SEM image analysis is common to measure mask LWR but the value depends on measurement parameters such as segment length of pattern edge. In this paper, optimum measurement conditions with SEM will be investigated and discussed using SEM images of actual mask and aerial simulation. And also we will report development status of actual mask LWR.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yuichi Inazuki, Tsukasa Abe, Tadahiko Takikawa, Hiroshi Mohri, and Naoya Hayashi "Characterization of line-width roughness about 22-32nm node EUV mask", Proc. SPIE 7748, Photomask and Next-Generation Lithography Mask Technology XVII, 774821 (26 May 2010); https://doi.org/10.1117/12.867910
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Line width roughness

Photomasks

Image segmentation

Scanning electron microscopy

Extreme ultraviolet

Extreme ultraviolet lithography

Semiconducting wafers

Back to Top